How To Cap A Toro Sprinkler Head Ideas. Sprinkler heads are not high enough.sprinkler heads sit just below or flush with the ground, so a sturdy trowel should be suitable for digging up the head.starting with the cap on the bottom of the two foot section, lightly sand the mating surfaces of the inside of the cap and outside of the pipe. Grasp the riser tube and pull until 4 inches or so of the tube extends from the ground.
Some heads have a slot on the side for adjusting the arc, which can be done with a rotor screwdriver or slotted screw.spray patterns for most pop up sprinkler heads are fixed.the arrow will point to the. This will increase your arc by 90 degrees each time you turn the wrench a full circle. Then, revolve it using your hand to.