th 1239

Whirlpool Duet Dryer Won T Start Stuck On Sensing

Whirlpool Duet Dryer Won T Start Stuck On Sensing. Any assistance would be greatly appreciated. My duet dryer won't start as it is stuck on sensing.

whirlpool dryer won't start says sensing Carlos Thrasher
whirlpool dryer won't start says sensing Carlos Thrasher from lalahostetler.blogspot.com

Whirlpool duet dryer will not start but powers on. So, i set down my breakfast bottle of tuckerman’s pale ale, saddled up the samurai repair van and peeled out. Any assistance would be greatly appreciated.

So There Are A Few Things That Can Cause This Issue.

If it checks good do this: Up to 20 cash back whirlpool cabrio dryer wont start. When we press start, the dryer clicks but doesn't get past the sensing light.

My Duet Dryer Won't Start As It Is Stuck On Sensing.

If the dryer is not level, the sensing does not work properly, and your drying cycle will end early. New whirlpool washer stuck on sensing. If the water drains from the unit, but your whirlpool washer won’t spin, you may have a problem with the shift actuator.

If The Dryer Is Not Level, The Sensing Does Not Work Properly, And Your Drying Cycle Will End Early.

As your load of laundry tumbles in the drum, it makes contact with the sensor strips so that the dryer can end the cycle when your laundry is dry. It is not likely the belt broke but the thermal fuse is certainly a possibility and i am including in the images below how to access and check the thermal fuse on most whirlpool duet dryers. Replacing the actuator may help you get into diagnostics and proceed with troubleshooting and resolution.

So, I Set Down My Breakfast Bottle Of Tuckerman’s Pale Ale, Saddled Up The Samurai Repair Van And Peeled Out.

If you remove the 3 screws along the bottom of the lower front panel, you can remove the lower front panel by pulling down and forward. All whirlpool duet dryers have sensor strips in the drum. That’s why your whirlpool dryer is stuck in sensing mode.

Unplug The Dryer And Look Behind The Lint Filter Enclosure To The Left.

Defective circuit board (or controller) bad moisture sensor; Empty your wet laundry into a tray. We opened the door and pressed the door switch, and the light stays on.

Leave a Reply

Your email address will not be published. Required fields are marked *